Ross CrossOver 12 Instrukcja Obsługi Pobierz pdf (Strona 20)

Move the fader to the position in the transition

where you want to set the transition limit point.

Toggle the Limit knob (On) to set the transition

limit point.

The segment on the transition progress bar next

to the fader handle ﬂashes, indicating the

location of the transition limit point.

The transition limit is set and active for the MLE you set

it on. You can turn transition limit on and off by toggling

the Limit knob while the fader is at either the top or

bottom limit. If the fader is not on a limit when you

toggle the transition limit on, a new transition limit will

be set. Double-press the Limit knob to reset the transition

limit point.

GPI Output Triggers

Each video source can have a GPI output assigned to it.

This GPI can be used to trigger an external device, such

as a video server, to play the cued clip when the video

sources from the video server are taken on-air. This

trigger can be set up to occur automatically any time the

video source is transitioned on-air, or it can be triggered

manually.

An automatic GPI output trigger can be overridden if

required.

Note: The Next Button Secondary Function must be set to

GPO to be able to trigger a GPI output manually using the NEXT

button.

Keep the following in mind when working with GPI

output triggers:

•

The RlClip knob must be set to On to trigger a

GPI output with a transition.

• Edge triggered GPI outputs remain triggered for

the conﬁgured duration.

• Level triggered GPI outputs toggle between high

and low each time they are triggered.

To Manually Trigger a GPI Output

The GPI must already be set up as a output and the Next

button functionality must be set to GPO before you can

manually trigger it.

Press and hold the NEXT button.

While holding the Next button, the

mnemonic/pattern buttons light for each GPI

output that is currently triggered.

Press the mnemonic/pattern button for the GPI

output you want to trigger. The number of the

GPI is shown on the mnemonics of the buttons.

The numbers on the pattern buttons on the

Carbonite 1 correspond to the GPI.

To Override a GPI Output

The RlClip personality option must be set to User for

you to override GPI output triggering.

Prepare the transition as required, but do not

perform the transition.

Press the transition type button again to bring up

the transition menus.

Use the RlClip knob to select whether the GPI

output is triggered (On), or is not triggered (Off).

20 • Transitions — Carbonite Operation Manual (v6.1)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Ross CrossOver 12 Instrukcja Obsługi Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Switche sieciowe Ross CrossOver 12